User`s guide

VigorTalk ATA24 Series User’s Guide
27
3
3
.
.
2
2
N
N
e
e
t
t
w
w
o
o
r
r
k
k
S
S
e
e
t
t
u
u
p
p
For Internet access, it is necessary for you to set WAN and MGN interfaces for the adapter.
3
3
.
.
2
2
.
.
1
1
W
W
A
A
N
N
a
a
n
n
d
d
I
I
n
n
t
t
e
e
r
r
n
n
e
e
t
t
A
A
c
c
c
c
e
e
s
s
s
s
S
S
e
e
t
t
u
u
p
p
The VigorTalk ATA-24 supports two WAN interfaces (with two IP Modes – Static or DHCP),
which share the same setting page. In the Network group, please click the WAN option. The
following page will be shown.
Backup Enables or disables backup function for WAN interfaces. If you enable
this function, the backup-master/backup-slave will execute the job of
master/slave device when the master/slave device fails to work.
Edit Open the configuration page of this WAN interface.
IP Mode Displays current mode of this WAN interface. There are two options:
Static or DHCP
Active Activates/closes this WAN interface.
Default Route Sets this WAN interface as default route interface.
Backup-Master Sets this WAN interface as a master interface. WAN1 must be assigned
as Master interface if Backup function is enabled.
Backup-Slave Sets this WAN interface as a slave interface.
VoIP Sets this WAN interface as VoIP default interface.
Most users will use their adapters primarily for Internet access. The VigorTalk ATA-24
supports broadband Internet access and provides multiple WAN interfaces. The following
sections will give a detailed illustration to broadband access methods.
Click the “Edit” icon to bring up the WAN configuration page for the corresponding interface.