User`s guide

VigorTalk ATA24 Series User’s Guide
13
2
2
.
.
2
2
.
.
3
3
D
D
H
H
C
C
P
P
M
M
o
o
d
d
e
e
DHCP allows a user to obtain an IP address automatically from a DHCP server on the Internet.
If you choose DHCP mode, the DHCP server of your ISP will assign a dynamic IP address for
VigorTalk ATA-24 automatically. It is not necessary for you to assign any setting. (Host
Name and Domain Name are required for some ISPs). S imply click Next to setup LAN
interface.
After setting up the WAN interface, the user can click Next to setup the LAN interface
continuously.
LAN – LAN IP/DHCP Page
IP Address Assign an IP address for the LAN interface.
Subnet Mask Assign the subnet mask for the LAN interface.
Status Click Enable to use DHCP server; click Disable to close
DHCP server; click Relay Agent to activate relay agent
function.
Start IP Assign the start IP address of the IP pool that DHCP server can
use for clients in LAN.
End IP Assign the end IP address of the IP pool that DHCP sever can
use for clients in LAN.