User`s guide

VigorTalk ATA24 Series User’s Guide
10
for VigorTalk ATA-24 incoming buffer adjustment. If you use a
DSL subscriber service with a 2Mbps downstream, please set the
downstream rate setting with 2Mbps.
Upstream Rate Assign the transmission rate for this WAN interface. The default
value is 102400 kbps (100 Megabit). This setting is very important
for VigorTalk ATA-24 outgoing buffer adjustment. If you use a DSL
subscriber service with a 256Kbps downstream, please set the
downstream rate setting with 256Kbps.
Type Select a connection type for this WAN interface. Currently, there is
only one setting offered for you to choose - Fast Ethernet.
Physical Mode Select connection speed mode for this WAN interface. There are
auto negotiation, full duplex, and half duplex of either
10/100/1000M speed options for the WAN Interface.
IP Mode Select an IP mode for this WAN interface. There are two available
modes for Internet access, Static or DHCP. On this page you may
configure the WAN interface to use Static (fixed IP) or DHCP
(dynamic IP address). Most of the cable users will use the DHCP
mode to get a globally reachable IP address from the cable host
system.