User`s guide

VigorTalk ATA24 Series User’s Guide
110
Detection, also known as Silence Suppression)
function.
“Disable” to stop using VAD. (Default is Disable)
<Active>
“Enable” to activate this port.
“Disable” to close this port. (Default is Disable)
<SIP Account>
1 to 32
<EntryIdx>
1 to 60
<MatchString>
Matched string, ex: 9011x.T, maximum 63
characters.
<MinLength>
Min. length of digits, range: 0~63, default: 0 (only
use for x.T (unfixed length) )
<MaxLength>
Max. length of digits, range: 0~63, default:32
<PrefixStrip>
Number of prefix digits to strip, range: 0~63
<PrefixAdd>
Prefix string to be add,
-1: none
maximum 63 char.
<SipIpAddr>
SIP IP address or domain name, ex: iptel.org 0 for
no specific address
<InterDigitTimeOut>
Override the inter-digits timeout, range: 1~60(sec)
default: 4 (sec)
<Memo>
User-specified name for comment, maximum 63
characters. Users can add some descriptions for
each number.
(Default is none)
<Mode>
0: Disable
1: RFC2833 (Default is 1)
2: SIP INFO
<SipInfoMode>
Click one option to be applied in DTMF function.
There are three options to be supported as below –
Disable(Inband)
RFC2833
SIP INFO
0: CISCO
1: NORTEL
(If Mode is 1, default is none)
(If Mode is 2, default is 0)
<Gain Value>
0 to 31
< Mode >
Select a mode to be applied on FAX function.
There are two options to be supported as below –
Transparent: FAX will be transmitted via voice
channel, no fax relay nor Codec change will be
involved.
T.38 Relay: Using T.38 Fax Relay. It is the default
value.
0: Transparent
1: T.38 Relay (Default is 1)
<Active >
0: Disable, 1: Enable
Or
0: off, 1: on
<Digits >
Default is none
< Proxy#>
Proxy # is from 1 to 3.
< Outbound >
0: Disable (Default is 0)