Operation Manual

VigorSwitch P2280 User’s Guide
130
Any – All packets will be filtered.
Or, enter the IP address to filter the packets coming from that
address.
Ethertype Specify ethernet type for filtering.
Select Any.
Or, enter the value with the format of “0x600 ~ 0xFFF”.
VLAN Specify VLAN profile for filtering.
Select Any.
Or, enter a VLAN number. The packets coming from the VLAN
specified here will be filtered by Vigor device.
802.1p Specify the 802.1p priority value for filtering. Select Any, or a
number from 0 to 7.
Add Click it to create a new ACE rule.
Modify
- click it to modify the settings for the selected entry.
- click it to remove the selected entry.
I
I
V
V
-
-
2
2
-
-
2
2
I
I
P
P
v
v
4
4
This page shows ACE based on IPv4 address. You may choose ACL, permit, and deny particular
packet or frame, even shutdown the port.
You may provide filtering/matching criteria for one or more of following packet characteristic
(such as Protocol over the IP layer, Source/Destination IPv4 address, Type of Service,
Source/Destination port number, TCP flags, ICMP Type, if chosen protocol contains ICMP), for
this ACE to identify the packet.
Available settings are explained as follows:
Item Description