Operation Manual

VigorSwitch P2121 User’s Guide

Available settings are explained as follows:

Item Description

ACL Profile Name Use the drop down list to selected one of the user defined ACL

profiles.

Sequence Assign a sequence number to this ACE. The sequence is used to

identify which one of ACEs in an ACL is firstly used to match

ingress packets. The switch port bound with an ACL use the

contained ACE rules, start with the one with lower sequence

number to match the packet first.

Action Select the action applied to the packet matched this ACE.

Permit or deny the packets into switch core, or shutdown the

port for stopping further transmission.

 Permit

 Deny

 Shutdown

Protocol Specify the protocol for filtering.

Any – All packets will be filtered.

Select – Choose one of the protocol (e.g., ICMP, IP in IP, TCP,

EGP, IGP…) from the drop down list. Packets passing through

the selected protocol will be filtered.

Define – Specify a type number (0 – 255) for ICMP code. For

example, 0 means “Echo Reply”; 254 means “RFC3692-style

Experiment 2”.

Source IP / Destination IP Specify the source and the destination IPv4 address for

filtering.

Any – All packets will be filtered.

Or, enter the IP address to filter the packets coming from that

address.

Service Any – All packets will be filtered.

DSCP – All IP traffic is mapped to queues based on the DSCP

field in the IP header. If traffic is not IP traffic, it is mapped to