Operation Manual

VigorSwitch P1100 User’s Guide
74
Parameter description:
State
Enable/Disable the STP on the specified port
Path Cost
Path cost is the cost of transmitting a frame on to a LAN
through that port. It is recommended to assign this value
according to the speed of the bridge. The slower the
media, the higher the cost. Entering 0 means the switch
will automatically assign a value.
Priority
Specify the STP priority on the specified port.
Edge Port
Set the edge port configuration:
Enable: Check the box to force to true state (as link to a
host)
Disable: Uncheck the box to force to false state (as link
to a host).
In the edge mode, the interface would be put into the
Forwarding state immediately upon link up. If the edge
mode is enabled for the interface and there are BPDUs
received on the interface, the loop might be occurred in
the short time before the STP state change.
Point-to-Point
Specify the Point-to-Point port configuration:
Auto: The state is depended on the duplex setting of the
port.
Enable: Click it to force to true state.
Disable: Click it to force to false state.