Operation Manual

VigorSwitch P1100 User’s Guide

discards and frame losses. Flow Control is used to

regulate transmission of signals to match the bandwidth

of the receiving port. The switch uses IEEE802.3x flow

control in full duplex mode and backpressure flow

control in half duplex mode. IEEE802.3x flow control is

used in full duplex mode to send a pause signal to the

sending port, causing it to temporarily stop sending

signals when the receiving port memory buffers fill. Back

Pressure flow control is typically used in half duplex

mode to send a "collision" signal to the sending port

(mimicking a state of packet collision) causing the

sending port to temporarily stop sending signals and

resend later.

Select “Auto”/ “Enable” to enable it. Or select

“Disable” to disable it.

Apply

Save the settings or changes to the switch.

Close the page and return to previous page.