Operation Manual

VigorSwitch P1100 User’s Guide

Default gateway:

For the routed packet, if the destination is not in the routing table, all the traffic is put into

the device with the designated IP address, known as default router. Basically, it is a routing

policy. The gateway setting is used for Trap Events Host only in the switch.

For assigning an IP address to the switch, you just have to check what the IP address of the

network will be connected with the switch. Use the same network address and append your

host address to it.

First, IP Address: as shown above, enter “192.168.1.224”, for instance. For sure, an IP

address such as 192.168.1.x must be set on your PC.

Second, Subnet Mask: as shown above, enter “255.255.255.0”. Any subnet mask such as

255.255.255.x is allowable in this case.

Note

: The DHCP Setting is enabled in default.