Operation Manual

VigorSwitch G2280 User’s Guide
72
Query Robustness – Set a number which allows tuning for the
expected packet loss on a subnet.
Query Interval – Specify the time interval for VigorSwitch to
send out general MLD query to the host (responsible for
responding). Later, based on the response, VigorSwitch can
forward the traffic through ports in VLAN.
Query Response Interval – Specify the time interval for
VigorSwitch to receive the query response from the host. If
time is up and no response received, the packets will be
blocked and discarded.
Last Member Query Counter – After quering for specified
times (defined here) and still not receiving any response from
the subscribed member, VigorSwitch will stop transmitting
data to the related GE port(s).
Last Member Query Interval – The maximum time interval
between counting each member query message with no
responses from any subscribed member.
Immediate Leave – Click Enable to enable the function of
immediate leave. When the GE/LAG port receives the leave
message, it will be removed from multicast group to speed up
leave latency.
OK - Apply the settings to the switch.
Cancel - Close the page and return to previous page.
I
I
I
I
-
-
7
7
-
-
4
4
-
-
2
2
M
M
L
L
D
D
S
S
t
t
a
a
t
t
i
i
c
c
G
G
r
r
o
o
u
u
p
p
The MLD static group is allowed to assign a VLAN/port as a specific IPv6 multicast member.
Every IPv6 multicast stream that belongs to the specified group IP address will be forwarded
to the specified port/VLAN member.
Available settings are explained as follows:
Item Description
VLAN ID Use the drop down list to specify a VLAN profile (created in
Switch LAN>>VLAN Management>>Create Vlan) as MLD
Static Group.
However, if State in MLD Setting is not set as Enabled, such
option will be disabled and no ID can be selected.
Group IP Address It is an identifier for the group member. Packets sent to such