Operation Manual

VigorSwitch G2280 User’s Guide
138
I
I
V
V
-
-
2
2
-
-
3
3
I
I
P
P
v
v
6
6
This page allows the network administrator to create ACE based on IPv6 address.
Available settings are explained as follows:
Item Description
ACL Profile Name Use the drop down list to selected one of the user defined ACL
profiles.
Sequence Assign a sequence number to this ACE. The sequence is used to
identify which one of ACEs in an ACL is firstly used to match
ingress packets. The switch port bound with an ACL use the
contained ACE rules, start with the one with lower sequence
number to match the packet first.
Action Select the action applied to the packet matched this ACE.
Permit or deny the packets into switch core, or shutdown the
port for stopping further transmission.
Permit
Deny
Shutdown
Protocol Specify the protocol for filtering.
Any – All packets will be filtered.
Select – Choose one of the protocol (e.g., ICMP, TCP, EGP…)
from the drop down list. Packets passing through the selected
protocol will be filtered.
Define – Specify a type number (0 – 255) for ICMP code. For
example, 0 means “Echo Reply”; 254 means “RFC3692-style
Experiment 2”.
Source IP / Destination IP Specify the source and the destination IPv6 address for
filtering.
Any – All packets will be filtered.
Or, enter the IPv6 address to filter the packets coming from
that address.
Service Any – All packets will be filtered.