Operation Manual

VigorSwitch G2280 User’s Guide
13
7
contained ACE rules, start with the one with lower sequence
number to match the packet first.
Action Select the action applied to the packet matched this ACE.
Permit or deny the packets into switch core, or shutdown the
port for stopping further transmission.
 Permit
 Deny
 Shutdown
Protocol Specify the protocol for filtering.
Any – All packets will be filtered.
Select – Choose one of the protocol (e.g., ICMP, IP in IP, TCP,
EGP, IGP…) from the drop down list. Packets passing through
the selected protocol will be filtered.
Define – Specify a type number (0 – 255) for ICMP code. For
example, 0 means “Echo Reply”; 254 means “RFC3692-style
Experiment 2”.
Source IP / Destination IP Specify the source and the destination IPv4 address for
filtering.
Any – All packets will be filtered.
Or, enter the IP address to filter the packets coming from that
address.
Service Any – All packets will be filtered.
DSCP – All IP traffic is mapped to queues based on the DSCP
field in the IP header. If traffic is not IP traffic, it is mapped to
the lowest priority queue.
IP Precedence - All IP traffic is mapped to queues based on
the IP Precedence field in the IP header. If traffic is not IP
traffic, it is mapped to the lowest priority queue.
Source Port / Destination
Port
Specify the source and destination port number for filtering
the packets.
Any – All packets will be filtered.
Single – Only the packets passing through the number defined
here will be filtered.
Range – Only the packets passing through the port range
defined here will be filtered.
ICMP Type Any – All packets will be filtered.
Select – Choose one of the type (e.g., Destination Unreachable
Echo Reply, MLD Query….) from the drop down list.
Define – Specify a type number (0 – 255) for ICMP code. For
example, 0 means “Echo Reply”; 254 means “RFC3692-style
Experiment 2”.
ICMP code Each ICMP type can be defined with different codes. For
example, if you define ICMP Type as “3”, then the available
codes for Type 3 will be 0-15.
Any – All packets will be filtered.
Or, enter 0 to 255 based on the ICMP type specifed.
Add Click it to create a new binding profile.
Modify
- click it to modify the settings for the selected entry.
- click it to remove the selected entry.