Operation Manual
VigorSwitch G2280 User’s Guide
136
address.
Ethertype Specify ethernet type for filtering.
Select Any.
Or, enter the value with the format of “0x600 ~ 0xFFF”.
VLAN Specify VLAN profile for filtering.
Select Any.
Or, enter a VLAN number. The packets coming from the VLAN
specified here will be filtered by Vigor device.
802.1p Specify the 802.1p priority value for filtering. Select Any, or a
number from 0 to 7.
Add Click it to create a new ACE rule.
Modify
- click it to modify the settings for the selected entry.
- click it to remove the selected entry.
I
I
V
V
-
-
2
2
-
-
2
2
I
I
P
P
v
v
4
4
This page shows ACE based on IPv4 address. You may choose ACL, permit, and deny particular
packet or frame, even shutdown the port.
You may provide filtering/matching criteria for one or more of following packet characteristic
(such as Protocol over the IP layer, Source/Destination IPv4 address, Type of Service,
Source/Destination port number, TCP flags, ICMP Type, if chosen protocol contains ICMP), for
this ACE to identify the packet.
Available settings are explained as follows:
Item Description
ACL Profile Name Use the drop down list to selected one of the user defined ACL
profiles.
Sequence Assign a sequence number to this ACE. The sequence is used to
identify which one of ACEs in an ACL is firstly used to match
ingress packets. The switch port bound with an ACL use the