Operation Manual

VigorSwitch G2280 User’s Guide
135
I
I
V
V
-
-
2
2
C
C
r
r
e
e
a
a
t
t
e
e
A
A
C
C
E
E
Since ACL based on MAC, IPv4 and/or IPv4 has been created on the section of IV-1, now you
can add multiple ACE rules for each ACL.
I
I
V
V
-
-
2
2
-
-
1
1
M
M
A
A
C
C
This page shows ACE based on MAC address. You may choose ACL, permit, and deny particular
packet or frame, even shutdown the port.
You may provide filtering/matching criteria for one or more of packet characteristic (such as
Source/Destination MAC, Ethertype, VLAN, 802.1p) for this ACE to identify the packet.
Available settings are explained as follows:
Item Description
ACL Profile Name Use the drop down list to selected one of the user defined ACL
profiles.
Sequence Assign a sequence number to this ACE. The sequence is used to
identify which one of ACEs in an ACL is firstly used to match
ingress packets. The switch port bound with an ACL use the
contained ACE rules, start with the one with lower sequence
number to match the packet first.
Action Select the action applied to the packet matched this ACE.
Permit or deny the packets into switch core, or shutdown the
port for stopping further transmission.
 Permit
 Deny
 Shutdown
Source MAC / Destination
MAC
Specify the source and the destination MAC address for
filtering.
Any – All packets will be filtered.
Or, enter the IP address to filter the packets coming from that