Operation Manual

VigorSwitch G2280 User’s Guide
102
I
I
I
I
I
I
-
-
4
4
-
-
2
2
M
M
a
a
n
n
a
a
g
g
e
e
m
m
e
e
n
n
t
t
A
A
c
c
c
c
e
e
s
s
s
s
C
C
o
o
n
n
t
t
r
r
o
o
l
l
E
E
n
n
t
t
r
r
i
i
e
e
s
s
(
(
A
A
C
C
E
E
)
)
This page allows a user to add, edit, or remove Access Control Entries (ACE) of the
Management Access Control profiles. However, only the ACE of inactive profiles can be
modified, and before configuring ACE, at least one ACL profile should be created.
Available settings are explained as follows:
Item Description
ACL Profile Name Use the drop-down list to select the inactive ACL profile you
would like to modify.
Priority Specify a priority number (1 to 65535) for such rule. The lower
the number, the higher the priority.
Service Choose the service type you would like to control the access.
Action Select the action to be taken on the traffic of selected service
type.
Deny – Incoming / outgoing data which meets ACE rules will be
blocked.
Permit – Incoming / outgoing data which meets ACE rule is
allowed to pass through.
Ports Select the ports to which the ACL should be applied.
IP Versions Specify the IP address/subnet to which the ACL should be
applied.
 All – All the IP address should be applied.
 IPv4 – Specify the IPv4 address /subnet.
IPv6 –Specify the IPv6 address /subnet.
IPv4 Enter the IPv4 address/subnet to which the ACE rule should
apply.
IPv6 Enter the IPv6 address/subnet to which the ACE rule should
apply.
Add Click it to create an ACE rule profile.
Then, such ACE rule profile will be shown on the table below.
Edit
- click it to modify the settings for the selected entry.