Operation Manual

VigorSwitch G2280 User’s Guide
96
I
I
I
I
I
I
-
-
1
1
R
R
A
A
D
D
I
I
U
U
S
S
This page allows the network administrator to add and configure multiple RADIUS servers.
Available settings are explained as follows:
Item Description
Use Default Parameters Retries - The retry time before this server being considered
not-reachable.
Timeout for Reply – Set the time (in seconds) before this
server being considered lost connection.
Key String – Enter the string used to encrypt and authenticate
with RADIUS server.
Apply - Save the settings.
Add RADIUS Server Address Type – Specify whether switch uses a hostname to
resolve address by DNS to connect to server, or directly
connect using IPv4 address.
Sever Address – Enter the server’s address corresponding with
address type given.
Server Port – Enter the port number used by RADIUS server.
Priorty - Specify the priority that switch uses this server. The
higher number, the lower priority. Switch will start with server
with lowest priority.
Retry – Set the time before this server being considered
not-reachable
Timeout – Set the time (in seconds) before this server being
considered lost connection.
Key String – Enter the key string used for encrypting and
authenticating with server. Unless Key String is specified here,
the default string will be used.
Usage –Specify whether you would like to use this server for
switch login authentication or 802.1x access port
authentication, or both.
Add – Click it to add a new RADIUS server and display in this
page.