Operation Manual

VigorSwitch G1280 User’s Guide
33
the VLAN group that the tag defines.
For port under Access Mode, VLAN ID provided as PVID would
automatically be selected as the untagged VLAN.
Accepted Type Specify the acceptable-frame-type of the specified interfaces.
It’s only available with Hybrid mode.
All - Accept frames regardless it's tagged with 802.1q or not.
Tag Only - Accept frames only with 802.1q tagged.
Untag Only - Accept frames untagged.
Ingress Filtering Enable the ingress filtering to filter out any packets not belong
to any VLAN members of this port. It is enabled automatically
while operating in Access and Trunk mode.
Enabled – Click it to enable the function.
Disabled - Click it to disable the function.
Tagged VLAN Specify the VLAN profile tagged in the VLAN.
Untagged VLAN Specify the VLAN profile untagged in the VLAN.
Forbidden VLAN Specify the VLAN profile forbidden in the VLAN.
Apply Save the settings or changes to the switch.
I
I
I
I
-
-
5
5
-
-
3
3
V
V
o
o
i
i
c
c
e
e
V
V
L
L
A
A
N
N
With such feature, a VLAN will be created temporarily and when the specified OUI device
delivers protocol packets related to “VoIP”, VigorSwitch will guide these packets into the
specified Voice LAN with specified priorioty tag to speed up the packet transmission. Such
voice VLAN is only active inside VigorSwitch for packet transmission. After these packets
leave VigorSwitch, the Voice VLAN tag will be removed immediately.
I
I
I
I
-
-
5
5
-
-
3
3
-
-
1
1
P
P
r
r
o
o
p
p
e
e
r
r
t
t
i
i
e
e
s
s
This page allows a user to configure global and per interface setting of voice VLAN.
Available settings are explained as follows:
Item Description
Voice VLAN State Enabled – Click it to enable Voice VLAN.