Operation Manual
Table Of Contents
- Table of Contents
- Part I Introduction
- Part II Switch LAN
- Part III Security
- Part IV QoS Configuration
- Part V System Maintenance
- Part VI Diagnostics
- Appendix: Reference
- Index
VigorSwitch G1280 User’s Guide
3
0
I
I
I
I
-
-
4
4
-
-
5
5
L
L
A
A
C
C
P
P
P
P
o
o
r
r
t
t
S
S
e
e
t
t
t
t
i
i
n
n
g
g
This section provides few detailed configuration regarding to Ports under LACP protocol.
Available settings are explained as follows:
Item Description
Ports Use the drop down list to specify LAN Port.
Priority Enter a port priority number for the port.
Timeout The timeout option decides how local switch of LAG
connection determines connection to be lost. Switch would
also notify the remote switch about this setting value, so that
remote switch can send LACP PDU in correct timing.
Long - LACP PDU will be sent every 30 seconds. If port member
is not seen over 90 seconds, it will cause port member
timeout.
Short - LACP PDU will be sent per second. If port member is
not seen over 3 seconds, it will cause port member timeout.
Apply Save the settings or changes to the switch.