Operation Manual

VigorSwitch G1260 User’s Guide

Parameter description:

SNMP enabled The term SNMP enable here is used for the activation or

de-activation of SNMP. Default is Disable.

Default SNMP function: Disable

SNMP Trap destination Set the IP address for the SNMP Trap Host.

SNMP Get Community

SNMP Set Community

SNMP Trap Community

Community name is used as password for authenticating

if the requesting network management unit belongs to the

same community group. If they both don’t have the same

community name, they don’t belong to the same group.

Hence, the requesting network management unit can not

access the device with different community name via

SNMP protocol; If they both have the same community

name, they can talk each other.

Community name is user-definable with a maximum

length of 15 characters and is case sensitive. There is not

allowed to put any blank in the community name string.

Any printable character is allowable.

The community name for each function works

independently. Each function has its own community

name. Say, the community name for Read only works for

Read function and can’t be applied to other function such

as Write and Trap.

Default community name for Get: public

Default community name for Set: private

Default community name for Trap: public

System Event There are two events (Cold Boot or Warm Boot) offered

here for you to set.

When VigorSwitch is boot by “cold boot” or “warm

boot”, it will send notification to SNMP server to inform