Operation Manual

VigorSwitch G1260 User’s Guide
66
Unlock Time The period (in seconds) for which a port will be kept
disabled in the event of a loop is detected (and the port
action is to shut down the port).
Port Display the number of the ports on the switch.
State Show the status on the port.
Protocol Enabled Controls whether Loop Detection is enabled on this
switch port.
When Port No is chosen and enable port's Loop detection,
the port can detect loop happens and port will be Locked.
If Loop did not happen, port maintains Unlocked.
Unlock port When ticking the port, port locked will be opened and
turned into unlocked. If not ticking the port, Port
maintains locked.
3
3
.
.
1
1
1
1
B
B
r
r
o
o
a
a
d
d
c
c
a
a
s
s
t
t
S
S
t
t
o
o
r
r
m
m
P
P
r
r
o
o
t
t
e
e
c
c
t
t
i
i
o
o
n
n
Function name:
Broadcast Strom Protection configuration
Function description:
When the broadcast packets received by the switch exceed the threshold configured, the
port will be blocked for a period of time which can be set. After a configured time, the
switch will detect whether the broadcast packets received on the port still exceed the
threshold. If the broadcast traffic is still higher than, the port will be closed for a period of
time again. If the broadcast traffic is under the threshold, the port will re-open and forward
the packets normally.
Parameter description:
Mode Controls whether Broadcast Strom Protection is enabled
(as a whole).