Operation Manual

VigorSwitch G1260 User’s Guide
45
Enable Jumbo Frames This function support jumbo frames of up to 9600 bytes,
Just tick the check box () to enable it.
Default: disable
Power Saving This function supports Power Saving.
Default: disable
Drop frames after excessive
collisions
Drop frames after excessive collisions.
After an excessive collision, the MAC drop frames might
occur. If yes, a frame is dropped after excessive collision.
This is IEEE Standard 802.3 half-duplex flow control
operation.
Link Show link status of this port.
Mode Set the speed and duplex of the port. If the media is
1Gbps fiber, there are three modes to choose: Auto
Speed, 1000/100 Full and Disable. If the media is TP,
the speed is Auto Speed, 10 /100 /1000 Mbps
(Full/Half) and Disabled. The following table
summarized the function the media supports.
In Auto mode, no default value.
Flow Control You can Just tick the check box () to enable flow
control. If flow control is set Enable, both parties can
send PAUSE frame to the transmitting device(s) if the
receiving port is too busy to handle. When it is set
Disable, there will be no flow control in the port. It drops
the packet if too much to handle.
Default: Disable