Installation guide

VigorPro 5500 Quick Start Guide
6
Interface Description
RST
(Factory Reset)
Restore the default settings.
Usage: Turn on the router (ACT LED is blinking). Press the hole and keep for
more than 5 seconds. When you see the ACT LED begins to blink rapidly than
usual, release the button. Then the router will restart with the factory default
configuration.
ISDN Connect for NT1 (or NT1+) box provided by ISDN service provider.
WAN(1/2) Connecter for remote networked devices.
LAN/Monitor Connecter for local networked devices.
LAN (1- 4) Connecter for local networked devices.
Connecter for a power cord with 100-240VAC (inlet).
Power Switch. “1” is ON; “0” is OFF.
1
1
.
.
2
2
P
P
a
a
c
c
k
k
a
a
g
g
e
e
C
C
o
o
n
n
t
t
e
e
n
n
t
t
nQuick Start Guide oCD p Antenna for G models
q
RJ-45 Cable (Ethernet) r RJ-45 to RJ-45 Cable
for i models
s
The type of the power cord depends on the country that the router will be installed:
UK-type power cord
EU-type power cord
USA/Taiwan-type power cord
AU/NZ-type power cord
* The maximum power consumption is 12-15 Watt.