User`s guide

VigorIPPBX 3510 Series User’s Guide
234
Check USB Disk to save the log to the attached USB diskette.
Syslog Server
Check it to make the syslog saved to the specified server.
USB Disk
Check it to make the syslog saved to the attached USB disk.
Router Name
Click the link to get the router name configured in System
Maintenance>>Management.
Syslog Server IP
The IP address of the Syslog server.
Destination Port
Assign a port for the Syslog protocol.
Enable syslog message
Check the box listed on this web page to send the
corresponding message of firewall, VPN, User Access, Call,
WAN, Router information to Syslog.
Enable (Alert Setup…)
Check “Enable” to activate function of mail alert.
Send a test e-mail
Make a simple test for the e-mail address specified in this page.
Please assign the mail address first and click this button to
execute a test for verify the mail address is available or not.
SMTP Server
The IP address of the SMTP server.
Mail To
Assign a mail address for sending mails out.
Return-Path
Assign a path for receiving the mail from outside.
Authentication
Check this box to activate this function while using e-mail
application.
User Name
Type the user name for authentication.
Password
Type the password for authentication.
Enable E-mail Alert
Check the box to send alert message to the e-mail box while the
router detecting the item(s) you specify here.
Click OK to save these settings.
For viewing the Syslog, please do the following:
1. Just set your monitor PC’s IP address in the field of Server IP Address
2. Install the Router Tools in the Utility within provided CD. After installation, click on
the Router Tools>>Syslog from program menu.