User`s guide

VigorIPPBX 3510 Series User’s Guide
199
Strip - When you choose this mode, partial or the whole
prefix number will be deleted according to the OP number.
Take the above picture (Prefix Table Setup web page) as an
example, the OP number of 886 will be deleted completely
for the prefix number is set with 886.
Replace - When you choose this mode, the OP number will
be replaced by the prefix number for calling out through the
specific VoIP interface. Take the above picture (Prefix Table
Setup web page) as an example, the prefix number of 03 will
be replaced by 8863. For example: dial number of
“031111111” will be changed to “88631111111” and sent to
SIP server.
OP Number
The front number you type here is the first part of the
account number that you want to execute special function
(according to the chosen mode) by using the prefix number.
Min Len
Set the minimal length of the dial number for applying the
prefix number settings. Take the above picture (Prefix Table
Setup web page) as an example, if the dial number is
between 7 and 9, that number can apply the prefix number
settings here.
Max Len
Set the maximum length of the dial number for applying the
prefix number settings.
Route
Choose the one that you want to enable the match prefix
settings from the saved SIP accounts. Please set up one SIP
account first to make this route available. This item will be
changed according to the port settings configured in IP
PBX>>PBX System>>Phone Settings and IP PBX>>Line
Settings>>SIP Trunk.