User`s guide

VigorIPPBX 3510 Series User’s Guide
97
VoIP Module Address Type in the IP address for VoIP connection. (Default:
192.168.1.249)
For IP Routing Usage Click Enable to invoke this function. The default setting is
Disable.
2
nd
IP Address Type in secondary IP address for connecting to a subnet.
(Default: 192.168.2.1/ 24)
2
nd
Subnet Mask An address code that determines the size of the network.
(Default: 255.255.255.0/ 24)
2
nd
DHCP Server You can configure the router to serve as a DHCP server for the 2nd
subnet.
Start IP Address: Enter a value of the IP address pool for the
DHCP server to start with when issuing IP addresses. If the 2nd IP
address of your router is 220.135.240.1, the starting IP address
must be 220.135.240.2 or greater, but smaller than
220.135.240.254.
IP Pool Counts: Enter the number of IP addresses in the pool. The
maximum is 10. For example, if you type 3 and the 2nd IP address
of your router is 220.135.240.1, the range of IP address by the
DHCP server will be from 220.135.240.2 to 220.135.240.11.
MAC Address: Enter the MAC Address of the host one by one
and click Add to create a list of hosts to be assigned, deleted or
edited IP address from above pool. Set a list of MAC Address for
2
nd
DHCP server will help router to assign the correct IP address of
the correct subnet to the correct host. So those hosts in 2
nd
subnet
won’t get an IP address belonging to 1
st
subnet.
RIP Protocol Control Disable deactivates the RIP protocol. It will lead to a stoppage of
the exchange of routing information between routers. (Default)