User`s guide

VigorFly 210 Series User’s Guide
121
Available parameters are explained as follows:
Item Description
Current System Time
Click Inquire Time to get the current time.
Use Browser Time
Select this option to use the browser time from the remote
administrator PC host as router’s system time.
Use NTP Client
Select to inquire time information from Time Server on the
Internet using assigned protocol.
Time Zone
Select the time zone where the router is located.
NTP Server
Type a new NTP server.
NTP synchronization
Select a time interval for updating from the NTP server.
After finishing all the settings here, please click OK to save the configuration.
3
3
.
.
9
9
.
.
8
8
M
M
a
a
n
n
a
a
g
g
e
e
m
m
e
e
n
n
t
t
This page allows you to manage the settings for access control, access list, port setup, and
SMP setup. For example, as to management access control, the port number is used to
send/receive SIP message for building a session.
Available parameters are explained as follows:
Item Description
Enable HTTP/ICMP
Ping/Telnet
Enable the checkbox to allow system administrators to login
from the Internet. There are several servers provided by the
system to allow you managing the router from Internet.
Check the box(es) to specify.
Access List
You could specify that the system administrator can only
login from a specific host or network defined in the list. A
maximum of three IPs/subnet masks is allowed.
List IP - Indicate an IP address allowed to login to the router.
Subnet Mask - Represent a subnet mask allowed to login to
the router.
Management Port Setting
Specify user-defined port numbers for the Telnet and HTTP