User`s guide

VigorFly 210 Series User’s Guide
106
Auto-reconnect Delay
After passing the time set here, the client will retry to
connect in case of failure or keepalive timeout.
0 means not retry.
Keepalive
Check the box to keep the connection between TSPC and
tunnel broker always on. TSPC will send ping packet to
make sure the connection between both ends is normal.
Keepalive Interval
Type the time for the interval between two keepalive
messages transferring from the client to the broker.
Prefix Length
Type the required prefix length for the client network.
Interface
Display LAN interface name. The name of the OS interface
that will be configured with the first 64 of the received
prefix from the broker and the router advertisement daemon
is started to advertise that prefix on the interface.
After finishing all the settings here, please click OK to save the configuration.
3
3
.
.
8
8
.
.
2
2
I
I
P
P
v
v
6
6
L
L
A
A
N
N
S
S
e
e
t
t
u
u
p
p
This page defines the IPv6 connection types for LAN interface. Possible types contain
DHCPv6 Server and RADVD. Each type requires different parameter settings.
Available settings are explained as follows:
Item Description
IPv6 Address
Type static IPv6 address for LAN.
Link Local Address
It is used for communicating with neighbouring nodes on
the same link. It is defined by the address prefix fe80::/10.
You don't need to setup Link-Local address manually for it
is generated automatically according to your MAC Address.
Autoconfiguration Type
The router provides one daemon for LAN side IPv6 address
configuration.
RADVD - The router advertisement daemon (radvd) sends
Router Advertisement messages, specified by RFC 2461, to
a local Ethernet LAN periodically and when requested by a
node sending a Router Solicitation message. These
messages are required for IPv6 stateless auto-configuration.