User`s guide

VigorAP 710 User’s Guide

Packet-OVERDRIVE

This feature can enhance the performance in data

transmission about 40%* more (by checking Tx Burst). It is

active only when both sides of Access Point and Station (in

wireless client) invoke this function at the same time. That is,

the wireless client must support this feature and invoke the

function, too.

Note: Vigor N61 wireless adapter supports this function.

Therefore, you can use and install it into your PC for

matching with Packet-OVERDRIVE (refer to the following

picture of Vigor N61 wireless utility window, choose Enable

for TxBURST on the tab of Option).

Antenna

VigorAP 710 can be attached with two antennas to have good

data transmission via wireless connection. However, if you

have only one antenna attached, please choose 1T1R.

Tx Power

The default setting is the maximum (100%). Lower down the

value may degrade range and throughput of wireless.

Channel Width

20 MHZ- the router will use 20Mhz for data transmission and

receiving between the AP and the stations.

Auto 20/40 MHZ– the router will use 20Mhz or 40Mhz for

data transmission and receiving according to the station

capability. Such channel can increase the performance for

data transit.

After finishing this web page configuration, please click OK to save the settings.