User`s guide

VigorAP 710 User’s Guide

Available settings are explained as follows:

Item Description

Enable Wireless LAN

Check the box to enable wireless function.

Enable Limit Client

Check the box to set the maximum number of wireless stations

which try to connect Internet through Vigor router. The

number you can set is from 3 to 64.

Mode

At present, VigorAP 710 can connect to 11b only, 11g only,

11n only, Mixed (11b+11g), Mixed (11g+11n) and Mixed

(11b+11g+11n) stations simultaneously. Simply choose Mixed

(11b+11g+11n) mode.

Hide SSID

Check it to prevent from wireless sniffing and make it harder

for unauthorized clients or STAs to join your wireless LAN.

Depending on the wireless utility, the user may only see the

information except SSID or just cannot see any thing about

VigorAP 710 while site surveying. The system allows you to

set three sets of SSID for different usage.

SSID

Set a name for VigorAP 710 to be identified. Default settings

are DrayTek.

Isolate Member

Check this box to make the wireless clients (stations) with the

same SSID not accessing for each other.

VLAN ID

Type the value for such SSID. Packets transferred from such

SSID to LAN will be tagged with the number.

If your network uses VLANs, you can assign the SSID to a

VLAN on your network. Client devices that associate using the

SSID are grouped into this VLAN. The VLAN ID range is

from 3 to 4095. The VLAN ID is 0 by default, it means

disabling the VLAN function for the SSID.

Mac Clone

Check this box and manually enter the MAC address of the

device with SSID 1. The MAC address of other SSIDs will

change based on this MAC address.