User manual

EZ Logger Lite - user manual -20-
Chapter 2:Web Interface for Configuration
This sets the access level to individual user accounts.
Administrator:
An Administrator has full access including write permission to
all menus and sub-sections. Only an Administrator can see
the User Name and IP address fields or set the camera
access Permit Hours to Operator or Viewer accounts.
Operator:
The user can access all menus, but does not have permission
to amend the data fields.
Viewer:
The user can only view camera within the time specified in
Permit Hours. The user does not have write permission,
can only view Camera A/B and read the Information section.
No Access:
This disables either of the above two permission levels given
to a user.
IP Filter
Use this feature to ensure that the user only login from the specified IP address.
Leave as *.*.*.* to allow the user to log into the account from any place.
Max FPS
This allows the Administrator to limit the bandwidth allocated to each account.
The Administrator can set a figure of 3 to Unlimited FPS (“frames per second”).
Viewing Hours
When the Permission level is set to either Operator or Viewer, the Administrator
can set the time to which the camera can be viewed.
Example:
Entering 192.168.1.* will only allow User to access from 192.168.1.xxx IP
addresses.
Note:
An Administrator account must be set before setting up either an Operator or
Viewer account. An administrator account fields, in this case, cannot be left empty.