User manual

EZ Logger Lite - user manual -18-
Chapter 2:Web Interface for Configuration
Account Name
Enter the login name assigned by your GSM/GPRS card.
Password
Enter the password assigned by your GSM/GPRS card.
3.2.4 Wireless Setting
This option determines EZ Logger Lite Wireless Network Settings. This option is
only configurable if a compatible wireless USB Adapter is attached. To set this up,
you’ll first need to use the LAN IP (as shown on the LCD) to access EZ Logger Lite.
i IP Address
Refer to section 3.2.3.4 (i) above. This will be the wireless LAN IP. It will be
different from the LAN IP.
ii DNS Server IP
Refer to section 3.2.3.4 (ii) above. This will be the wireless DNS server IP. It
can be different from that of the LAN IP.
iii Wireless
Connect a compatible Wireless USB Adapter to enable this feature.
Fig.17 EZ Logger Lite Wireless Setup
Connect to Wireless AP
When a compatible Wireless USB Adapter is connected, select Yes and click
Search Wireless AP button to have it search for nearby Access Points (AP).
Once detected all available AP will be displayed on the table to the right.
Select the preferred AP and click << button to add it to the SSID field.
Note:
Once the wireless configuration is setup, the wireless IP address will be shown on the LCD
instead of the LAN IP. To check the LAN IP thru the LCD, unplug the wireless USB adapter.
Note:
Pay attention to enable this function, it may cost expensive communication
charge to you.
Contact with your GPRS provider for
understand
charge rate.