Operation Manual

Vigor300B Series User’s Guide
29
a. Enter rule name.
b. Enable this rule.
c. Select Source Type as Subnet, and enter the IP address and Subnet Mask of
LAN1.
d. Select Out-Going Rule as User Defined, and Interface as WAN1.
e. Enable Failover to Next Rule so that when WAN1 fails, it will follow the next
rule.
f. Click Apply to save the configuration.
With the above configuration, traffic from LAN1 will be sent to WAN1. When WAN1 is
not available, because Failover to Next Rule in enabled, the router will check if there is
another Policy Rule matched. If there is not, the Default Route will be applied.
2. Similarly, add a Policy Rule for traffic from LAN2 to go to the Internet via WAN2.
3. Configure the Default Route at Routing >>Default Route.
Default Route is the rule to be applied if there are no Policy Rule matched. You may set
Default Route to a specific WAN interface or to “default pool”. Enable “Auto Failover
to Active WANs” will swap the sessions to other active WANs when the original WAN
connection is lost.