Operation Manual

Vigor300B Series User’s Guide
127
Alias
WAN IP alias that can be selected and used for port
redirection. Before using it, please go to WAN>>General
Setup and enable the wan1 profile. Add several IP addresses
under Static mode for wan1.
Protocol
Choose the protocol used for the entry.
Public Port Start/
Public Port End
It is available when Range to One or Range to Range
(port) or Range to Range (IP) is selected as Port
Redirection Mode.
Type the starting/ending number of the public port.
For Range-to-One, set both Start and End values with the
same value.
Private IP Start /
Private IP End
It is available when Range to Range (IP) is selected as Port
Redirection Mode.
Type the starting/ending IP address.
Private IP
Specify the private IP address of the internal host providing
the service. Simply type the private IP used for this entry.
Private Port
Type a port number for such profile.
Apply
Click it to save and exit the dialog.
Cancel
Click it to exit the dialog without saving anything.
4. Enter all the settings and click Apply.
5. A new profile has been added onto Port Redirection table.