User`s guide

Vigor2960 Series User’s Guide
309
Local IP / Subnet Mask
Display the LAN IP address with subnet mask of this profile.
Remote Host
Display the name of the remote host of this profile.
Remote IP / Subnet
Mask
Display the WAN IP address with subnet mask of this
profile.
More Remote Subnet
Display other LAN IP addresses with subnet mask which can
be used of this profile.
H
H
o
o
w
w
t
t
o
o
c
c
r
r
e
e
a
a
t
t
e
e
a
a
n
n
I
I
P
P
s
s
e
e
c
c
V
V
P
P
N
N
p
p
r
r
o
o
f
f
i
i
l
l
e
e
The IPsec services can provide access control, connectionless integrity, data origin
authentication, rejection of replayed packets that is a form of partial sequence integrity, and
confidentiality by encryption. These objectives are met through the use of two traffic
security protocols, the Authentication Header (AH) and the Encapsulating Security Payload
(ESP), and through the use of cryptographic key management procedures and protocols.
1. Open VPN and Remote Access >> VPN Profiles.
2. Simply click the Add button.
3. The following dialog will appear. Click the Basic tab to configure the settings.
Available parameters are listed as follows:
Item Description
Profile
Type the name of the profile.
Enable
Check this box to enable this profile.
Type
There are three types offered here for you to choose. Please
choose IPsec for this case.
Basic
Auto Dial-Out – Click Enable to make Vigor router
performing VPN connection based on the condition selected
(e.g., Always Dial-Out, if.wan1/wan2/usb1/usb2 down).