User`s guide

Vigor2960 Series User’s Guide
300
displayed here.
Local IP / Subnet
Mask
Type the IP address and subnet mask of local host.
Remote IP / Subnet
Mask
Type the LAN IP address and LAN subnet mask for the
remote host.
Netbios Naming
Packet
Enable – Click it to have an inquiry for data transmission
between the hosts located on both sides of VPN Tunnel
while connecting.
Disable –When there is conflict occurred between the hosts
on both sides of VPN Tunnel in connecting, such function
can block data transmission of Netbios Naming Packet inside
the tunnel.
If you choose IPsec as the Type in Step 1, you will get the following page:
Available parameters are listed as follows:
Item Description
Profile
Display the name of the VPN profile.
Enable
Check this box to enable such profile.
WAN Profile
Choose a WAN profile to be used by such profile.
Local IP/Subnet
Mask
Type the IP address and subnet mask of local host.
Local Next Hop
Specify the gateway for WAN interface. Usually, use the
default setting (leave it in blank).
Remote Host
Type the WAN IP address for the remote host.
Remote IP / Subnet
Type the LAN IP address and LAN subnet mask for the