User`s guide

Vigor2910 Series User’s Guide
132
More Add a static route to direct all traffic destined to more Remote
Network IP Addresses/ Remote Network Mask through the
VPN connection. This is usually used when you find there are
several subnets behind the remote VPN router.
RIP Direction The option specifies the direction of RIP (Routing Information
Protocol) packets. You can enable/disable one of direction
here. Herein, we provide four options: TX/RX Both, TX Only,
RX Only, and Disable.
RIP Version Select the RIP protocol version. Specify Ver. 2 for greatest
compatibility.
From first subnet to
remote network, you have
to do
If the remote network only allows you to dial in with single
IP, please choose NAT, otherwise choose Route.
Change default route to
this VPN tunnel (Only
single WAN supports this )
Check this box to change the default route with this VPN
tunnel. Be aware that this setting is available only for one
WAN interface is enabled. It is not available when both
WAN interfaces are enabled.