User`s guide

Vigor2850 Series User’s Guide
4
1
1
.
.
2
2
.
.
2
2
F
F
o
o
r
r
V
V
i
i
g
g
o
o
r
r
2
2
8
8
5
5
0
0
n
n
LED Status Explanation
Blinking The router is powered on and running normally. ACT (Activity)
Off The router is powered off.
On USB device is connected and ready for use. USB
Blinking The data is transmitting.
On Internet connection is ready.
Off Internet connection is not ready.
WAN2
Blinking The data is transmitting.
On
Wireless access point is ready.
WLAN
Blinking
It will blink slowly while wireless traffic goes
through.
If ACT and WLAN LEDs blink quickly and
simultaneously when WPS is working, and it will
return to normal condition after two minutes. (You
need to setup WPS within 2 minutes.)
On The router is ready to access Internet through
ADSL link.
ADSL
Blinking Slowly: The ADSL connection is ready.
Quickly: The connection is training.
On The router is ready to access Internet through
VDSL link.
VDSL
Blinking Slowly: The VDSL connection is ready.
Quickly: The connection is training.
On The DoS/DDoS function is active. DoS
Blinking It will blink while an attack is detected.
VPN On The VPN tunnel is active.
QoS
On The QoS function is active.
LED on Connector
On The port is connected.
Off The port is disconnected.
Left LED
(Green)
Blinking The data is transmitting.
On The port is connected with 1000Mbps.
GigaLAN 1/2/3
Right LED
(Green)
Off The port is connected with 10/100Mbps.
On The port is connected.
Off The port is disconnected.
Left LED
(Green)
Blinking The data is transmitting.
On The port is connected with 1000Mbps.
GigaLAN 4/WAN
(Giga)
Right LED
(Green)
Off The port is connected with 10/100Mbps.