User`s guide

Vigor2850 Series User’s Guide
131
must be 192.168.1.2 or greater, but smaller than 192.168.1.254.
IP Pool Counts - Enter the maximum number of PCs that you
want the DHCP server to assign IP addresses to. The default is
50 and the maximum is 253.
Use LAN Port – Specify an IP for IP Route Subnet. If it is
enabled, DHCP server will assign IP address automatically for
the clients coming from P1 and/or P2. Please check the box of
P1 and P2.
Use MAC Address - Check such box to specify MAC address.
MAC Address: Enter the MAC Address of the host one by one
and click Add to create a list of hosts to be assigned, deleted or
edited IP address from above pool. Set a list of MAC Address
for 2
nd
DHCP server will help router to assign the correct IP
address of the correct subnet to the correct host. So those hosts
in 2
nd
subnet won’t get an IP address belonging to 1
st
subnet.
Add – Type the MAC address in the boxes and click this button
to add.
Delete – Click it to delete the selected MAC address.
Edit – Click it to edit the selected MAC address.
Cancel – Click it to cancel the job of adding, deleting and
editing.
4
4
.
.
2
2
.
.
3
3
S
S
t
t
a
a
t
t
i
i
c
c
R
R
o
o
u
u
t
t
e
e
Go to LAN to open setting page and choose Static Route.
Index
The number (1 to 10) under Index allows you to open next page
to set up static route.
Destination Address
Displays the destination address of the static route.
Status
Displays the status of the static route.
Viewing Routing Table
Displays the routing table for your reference.