User`s guide

Vigor2850 Series User’s Guide
126
4
4
.
.
2
2
.
.
2
2
G
G
e
e
n
n
e
e
r
r
a
a
l
l
S
S
e
e
t
t
u
u
p
p
This page provides you the general settings for LAN. Click LAN to open the LAN settings
page and choose General Setup.
There are four subnets provided by the router which allow users to divide groups into different
subnets (LAN1 – LAN4). In addition, different subnets can link for each other by configuring
Inter-LAN Routing. At present, LAN1 setting is fixed with NAT mode only. LAN2 – LAN4
can be operated under NAT or Route mode. IP Routed Subnet can be operated under Route
mode.
General Setup-----
Allow to configure settings for each subnet respectively.
Index
Display all of the LAN items.
Status
Basically, LAN1 status is enabled in default. LAN2, LAN3,
LAN3 and IP Routed Subnet can be observed by checking the
box of Status.
DHCP
LAN1 is configured with DHCP in default. If required, please
check the DHCP box for each LAN.
IP Address
Display the IP address for each LAN item. Such information is
set in default and you can not modify it.
Details Page
Click it to access into the setting page. Each LAN will have
different LAN configuration page. Each LAN must be
configured in different subnet.
Inter-LAN Routing
Check the box to link two or more different subnets (LAN and
LAN).