User`s guide
Table Of Contents
- Table of Contents
- 1. Preface
- 2. Initial Configuration
- 3. Advanced Configuration
- 4. Application and Examples
- 4.1 How to Configure Multi-Subnet in Vigor2830
- 4.2 How Can I Use FTP to Get the Files from USB Storage DeviceConnecting to Vigor Router?
- 4.3 How to Send out SMS via Vigor Router
- 4.4 Web Portal Log-In Application for Wireless Client
- 4.5 How to Customize Your Login Page
- 4.6 Create a LAN-to-LAN Connection Between Remote Officeand Headquarter
- 4.7 Create a Remote Dial-in User Connection Between theTeleworker and Headquarter
- 4.8 QoS Setting Example
- 4.9 Upgrade Firmware for Your Router
- 4.10 Request a certificate from a CA server on Windows CAServer
- 4.11 Request a CA Certificate and Set as Trusted on WindowsCA Server
- 4.12 Creating an Account for MyVigor
- 5. Trouble Shooting
- 5.1 Checking If the Hardware Status Is OK or Not
- 5.2 Checking If the Network Connection Settings on YourComputer Is OK or Not
- 5.3 Pinging the Router from Your Computer
- 5.4 Checking If the ISP Settings are OK or Not
- 5.5 Problems for 3G Network Connection
- 5.6 Backing to Factory Default Setting If Necessary
- 5.7 Contacting Your Dealer
Vigor2830 Series User’s Guide
43
3
3
.
.
1
1
.
.
2
2
G
G
e
e
n
n
e
e
r
r
a
a
l
l
S
S
e
e
t
t
u
u
p
p
This section will introduce some general settings of Internet and explain the connection modes
for WAN1, WAN2 and WAN3 in details.
This router supports multiple-WAN function. It allows users to access Internet and combine
the bandwidth of the multiple WANs to speed up the transmission through the network. Each
WAN port can connect to different ISPs, Even if the ISPs use different technology to provide
telecommunication service (such as DSL, Cable modem, etc.). If any connection problem
occurred on one of the ISP connections, all the traffic will be guided and switched to the
normal communication port for proper operation. Please configure WAN1, WAN2 and WAN3
settings.
This webpage allows you to set general setup for WAN1, WAN2 and WAN3 respectively.
Detailed explanation is shown below:
Item Description
Load Balance Mode
This option is available for multiple-WAN for getting
enough bandwidth for each WAN port. If you know the
practical bandwidth for your WAN interface, please choose
the setting of According to Line Speed. Otherwise, please
choose Auto Weigh to let the router reach the best load
balance.
Index
Click the WAN interface link under Index to access into the
WAN configuration page.
Enable
V means such WAN interface is enabled and ready to be
used.
Physical Mode / Type
Display the physical mode and physical type of such WAN
interface.
Line Speed
Display the downstream and upstream rate of such WAN
interface.