User`s guide
Table Of Contents
- Table of Contents
- 1. Preface
- 2. Initial Configuration
- 3. Advanced Configuration
- 4. Application and Examples
- 4.1 How to Configure Multi-Subnet in Vigor2830
- 4.2 How Can I Use FTP to Get the Files from USB Storage DeviceConnecting to Vigor Router?
- 4.3 How to Send out SMS via Vigor Router
- 4.4 Web Portal Log-In Application for Wireless Client
- 4.5 How to Customize Your Login Page
- 4.6 Create a LAN-to-LAN Connection Between Remote Officeand Headquarter
- 4.7 Create a Remote Dial-in User Connection Between theTeleworker and Headquarter
- 4.8 QoS Setting Example
- 4.9 Upgrade Firmware for Your Router
- 4.10 Request a certificate from a CA server on Windows CAServer
- 4.11 Request a CA Certificate and Set as Trusted on WindowsCA Server
- 4.12 Creating an Account for MyVigor
- 5. Trouble Shooting
- 5.1 Checking If the Hardware Status Is OK or Not
- 5.2 Checking If the Network Connection Settings on YourComputer Is OK or Not
- 5.3 Pinging the Router from Your Computer
- 5.4 Checking If the ISP Settings are OK or Not
- 5.5 Problems for 3G Network Connection
- 5.6 Backing to Factory Default Setting If Necessary
- 5.7 Contacting Your Dealer
Vigor2830 Series User’s Guide
241
Below shows Wireless LAN>>WPS web page.
Available settings are explained as follows:
Item Description
Enable WPS
Check this box to enable WPS setting.
WPS Status
Display related system information for WPS. If the wireless
security (encryption) function of the router is properly
configured, you can see ‘Configured’ message here.
SSID
Display the SSID1 of the router. WPS is supported by
SSID1 only.
Authentication Mode
Display current authentication mode of the router. Only
WPA2/PSK and WPA/PSK support WPS.
Configure via Push
Button
Click Start PBC to invoke Push-Button style WPS setup
procedure. The router will wait for WPS requests from
wireless clients about two minutes. The WPS LED on the
router will blink fast when WPS is in progress. It will return
to normal condition after two minutes. (You need to setup
WPS within two minutes)
Configure via Client
PinCode
Please input the PIN code specified in wireless client you
wish to connect, and click Start PIN button. The WPS
LED on the router will blink fast when WPS is in progress.
It will return to normal condition after two minutes. (You
need to setup WPS within two minutes)