User`s guide
Table Of Contents
- Table of Contents
- 1. Preface
- 2. Initial Configuration
- 3. Advanced Configuration
- 4. Application and Examples
- 4.1 How to Configure Multi-Subnet in Vigor2830
- 4.2 How Can I Use FTP to Get the Files from USB Storage DeviceConnecting to Vigor Router?
- 4.3 How to Send out SMS via Vigor Router
- 4.4 Web Portal Log-In Application for Wireless Client
- 4.5 How to Customize Your Login Page
- 4.6 Create a LAN-to-LAN Connection Between Remote Officeand Headquarter
- 4.7 Create a Remote Dial-in User Connection Between theTeleworker and Headquarter
- 4.8 QoS Setting Example
- 4.9 Upgrade Firmware for Your Router
- 4.10 Request a certificate from a CA server on Windows CAServer
- 4.11 Request a CA Certificate and Set as Trusted on WindowsCA Server
- 4.12 Creating an Account for MyVigor
- 5. Trouble Shooting
- 5.1 Checking If the Hardware Status Is OK or Not
- 5.2 Checking If the Network Connection Settings on YourComputer Is OK or Not
- 5.3 Pinging the Router from Your Computer
- 5.4 Checking If the ISP Settings are OK or Not
- 5.5 Problems for 3G Network Connection
- 5.6 Backing to Factory Default Setting If Necessary
- 5.7 Contacting Your Dealer
Vigor2830 Series User’s Guide
180
3. After finishing the configuration, please click Next. The confirmation page will be shown
as follows. If there is no problem, you can click one of the radio buttons listed on the page
and click Finish to execute the next action.
Available settings are explained as follows:
Item Description
Go to the VPN
Connection
Management
Click this radio button to access VPN and Remote
Access>>Connection Management for viewing VPN
Connection status.
Do another VPN
Server Wizard Setup
Click this radio button to set another profile of VPN Server
through VPN Server Wizard.
View more detailed
configuration
Click this radio button to access VPN and Remote
Access>>LAN to LAN for viewing detailed configuration.
3
3
.
.
1
1
0
0
.
.
3
3
R
R
e
e
m
m
o
o
t
t
e
e
A
A
c
c
c
c
e
e
s
s
s
s
C
C
o
o
n
n
t
t
r
r
o
o
l
l
Enable the necessary VPN service as you need. If you intend to run a VPN server inside your
LAN, you should disable the VPN service of Vigor Router to allow VPN tunnel pass through,
as well as the appropriate NAT settings, such as DMZ or open port.