User`s guide

Vigor2760 Series User’s Guide
48
Confirm PPP
Password
Type the password again for confirmation.
Default Route
Check the box to enable the default route for such WAN
profile.
Apply
Click it to save the settings.
Clear
Click it to remove the modification of the web page.
Cancel
Click it to return to previous web page.
3. After finished the settings above, click Apply to save the settings then click Cancel to
return to previous page.
4
4
.
.
1
1
.
.
1
1
.
.
1
1
0
0
W
W
A
A
N
N
D
D
S
S
L
L
M
M
o
o
d
d
e
e
The DSL mode tab is used to configure which xDSL mode is used by the router. Please
configure this according to the DSL type provided by the ISP. The DSL mode configured in
the profiles under the DSL Mode tab will work only if they match the configurations here.
Available parameters are listed below:
Item Description
Physical Type
Use the drop down list to specify the physical type of the
WAN interface.
Auto: The router will detect which mode that the ISP is
using. Usually it might be ADSL1/2/2+ or VDSL2.
ADSL Multimode: The DSL physical type can be ADSL,
ADSL2 or ADSL2+.
VDSL only: The DSL interface is fixed with VDSL only.
DSL Debug Mode
Check it to enable the debug mode to find out the problem
via DSL synchronization.
Apply
Click it to save the settings.
Clear
Click it to remove the modification of the web page.
Refresh
Click it to refresh the web page.