User`s guide

Vigor2760 Series User’s Guide
180
still active; Clear means such VPN connection will be down.
Dead Peer Detection – Delay Time (sec) – It is available
when Clear is selected for Dead Peer Detection above. Set
the interval for the detection. The default setting shall be “30”
seconds.
Dead Peer Detection – Timeout (sec) –It is available when
Clear is selected for Dead Peer Detection above. Set the time
that the system will wait for the response. The default setting
shall be “120” seconds. In default, the detection will be done
for four times within the default time. If there is no response,
the VPN tunnel will be disconnected.
Network
My WAN IP
This field is only applicable when you select L2TP as the
server type and enable L2TP over IPsec.
Type the WAN IP address for the VPN tunnel.
LAN Interface
Use the drop down list to specify a LAN profile.
Apply
Click it to save the settings.
Clear
Click it to remove the modification of the web page.
Cancel
Click it to exit the web page without saving the configuration.
After finished the settings above, click Apply to save the settings.