User`s guide

Vigor2710 Series User’s Guide
129
number to edit or clear the corresponding entry.
Protocol
Display the protocol used for this address mapping.
Public IP
Display the public IP address selected for this entry, e.g.,
172.16.3.102.
Private IP
Display the private IP set for this address mapping, e.g.,
192.168.1.10.
Mask
Display the subnet mask selected for this address mapping.
Status
Display the status for the entry, enable or disable.
Click the index number link to open the configuration page.
Available settings are explained as follows:
Item Description
Enable
Check to enable this entry.
Protocol
Specify the transport layer protocol. It could be TCP, UDP,
or ALL for selection.
WAN Interface
Choose the WAN interface for such address mapping profile.
WAN IP
This is the source IP of a packet captured on the WAN side
and sent by a NAT host specified in the Private IP field.
The drop down menu contains WAN interface IPs and WAN
IP alias IPs.
Private IP
This is the source IP of a NAT host which wishes to send
packets to the WAN side and have source address as
configured in the WAN IP field.
Subnet Mask
Select a value of subnet mask for private IP address.
After finishing all the settings here, please click OK to save the configuration.