Installation guide

Vigor 2710 Series Quick Start Guide
8
1
1
.
.
1
1
.
.
4
4
F
F
o
o
r
r
V
V
i
i
g
g
o
o
r
r
2
2
7
7
1
1
0
0
V
V
D
D
n
n
LED Status Explanation
Blinking The router is powered on and
running normally.
ACT
(Activity)
Off The router is powered off.
On Wireless access point is ready. WLAN
Blinking It will blink while wireless traffic
goes through.
On The router is ready to access
Internet through DSL link.
DSL
Blinking Slowly: The modem is ready.
Quickly: The connection is training.
On The port is connected.
Off The port is disconnected.
LAN
1/2/3/4
Blinking The data is transmitting.
On A USB device is connected and
active.
USB
Blinking The data is transmitting.
On DECT phone is in use
Off DECT phone is idle or off.
DECT
Blinking A DECT phone call comes.
On The phone connected to this port is
off-hook.
Off The phone connected to this port is
on-hook.
Phone
Blinking A phone call comes.
On A PSTN phone call comes (in and
out). However, when the phone call
is disconnected, the LED will be off
about six seconds later.
Line
Off There is no PSTN phone call.
On The WPS is on.
Off The WPS is off.
WPS
Blinking Waiting for wireless client sending
requests for connection or DECT
handset about two minutes.
On
DECT Pairing and WPS: Press
and hold the button for more than 2
seconds then you could try to
register DECT phone with 2710
within 2 minutes.
DECT Paging: Press once. All
handsets will have beep sound,
press the button again or press any
key on any handset will stop the
beep sound.
Off The WPS is off.
DECT
Pairing/Pag
ing / WPS
Button
Blinking Waiting for wireless client sending
requests for connection about 2
minutes.