Installation guide

12
Install ‘ Router Tools ‘ This tool which provides ‘Smart StartWizard’, ‘Firmware Upgrade Program ’
and ‘TFTP client’ is in the attached CD. It supportsWindows, Mac OS 8/9 and
Mac OS X. Moreover, it provides ‘Syslog Tool” for Windows system. For
Vigor2600X and Vigor2600W models, there is vitual TA program for the usage of
ISDN AP.
Turn on your router
Once all previous steps are completed, turn on your router. After Power is on,
the ‘ACT’ LED and corresponding LAN port LED will light.
If the LEDs do not light normally, please refer to section A, ‘Trouble Shooting’,
for furthur information.
Connect to router
If the PC is set to obtain IP address automatically (recommended), you can
useWindows winipcfg.exe or ipconfig.exe to check if it has obtained an IP address
from the router. If not, please reboot PC and ensure that it has obtained an IP address
from the router.
Then you can use ‘Smart StartWizard’ to confige router or connect to router viaWeb
browser directly. The default IP of router is 192.168.1.1.
Password The default password is null. You can press ‘OK’ to skip it.