Installation guide

5
Vigor2500Wt
LED Indicators Descriptions
ACT(Activity)
ADSL
Blink when power is supplied to the router and the router is running normally.
LINE
DATA
ON when the ADSL network is correctly setup
Blinking indicates the DSL protocols start handshaking.The light will
remain still when data transmission is available.
Descriptions
LAN 1-4
Link
100Mbps
Local Area Network port status. A steady LED indicates a
connection between computers on your LAN. A flickering LED
indicates data transmission.
Speed status of the Ethernet connection. A steady LED indicates
100Mbps speed. If the Link light is on and the 100Mbps light is off,
the speed is 10Mbps.
VPN
WL
VPN connection status. A steady LED indicates VPN connection is up.
ON when the wireless LAN is ready.A flickering LED indicates data transmission.
ON/OFF
PWR
ON / turn on power. OFF / switch off the power.
Only the power adapter comes with the package can be connected
to the AC 9V power jack.
To connect Vigor 2500Wt to an electrical outlet.
P1,P2,P3,P4
These switch ports should be connected to your local PCs.
ADSL
To connect the ADSL cable to your telephone jack.
Factory Reset
The restore default settings: While the router is running (ACT LED blinking), press the
button and hold for more than five seconds. The ACT LED begins to blink rapidly, then
release the button . The router will restart with the factory default configuration.
Back Panels