User`s guide

Vigor2130 Series User’s Guide
238
Item Description
IPv6 Link local Address - It is used for communicating
with neighbouring nodes on the same link. It is defined by
the address prefix fe80::/10. You don't need to setup
Link-Local address manually for it is generated
automatically according to your MAC Address.
RADVD (Stateless)
The router advertisement daemon (radvd) sends Router
Advertisement messages, specified by RFC 2461, to a local
Ethernet LAN periodically and when requested by a node
sending a Router Solicitation message. These messages are
required for IPv6 stateless auto-configuration.
Enable - Check this box to enable RADVD function for
IPv6 connection.
Advertisement lifetime - The lifetime associated with the
default router in units of seconds. It's used to control the
lifetime of the prefix. The maximum value corresponds to
18.2 hours. A lifetime of 0 indicates that the router is not a
default router and should not appear on the default router
list.
DHCPv6 (Stateful)
IPv6 Start Address/IPv6 End Address - Type the start
and end address for IPv6 server.
4
4
.
.
1
1
3
3
.
.
3
3
I
I
P
P
v
v
6
6
F
F
i
i
r
r
e
e
w
w
a
a
l
l
l
l
S
S
e
e
t
t
u
u
p
p
This page allows users to set firewall rules for IPv6 packets.
Note: Section 4.4 Firewall is configured for IPv4 packets only.
Each item is explained as follows:
Item Description
Name
Display the name of the rule.
Protocol
Display the protocol (TCP/UDP/ICMPv6) the rule uses.
Source IP
Display the source IP address of such rule.
Destination IP
Display the destination IP address of such rule.
Source Port
Display the source port number of such rule.
Destination Port
Display the destination port number of such rule
Action
Display the status (accept or drop) of such rule.