User`s guide

Vigor2130 Series User’s Guide
105
To add a new police route, please click Add to open the following page.
Available settings are explained as follows:
Item Description
Enable
Check it to enable such route.
Source IP Address
Type the source address for such policy route.
Subnet Mask
Type the subnet mask for such policy route.
Destination IP Address
Type the destination address for such policy route.
Subnet Mask
Type the subnet mask for destination for such policy route.
Gateway IP Address
Type the gateway IP address for the policy route.
Interface
Choose an interface used by such policy route.
Do NAT for Source
Subnet
Except LAN option, any option selected as the Interface
allows you to enable or disable such feature.
Status
Display the status of the policy route.
After finishing all the settings here, please click OK to activate them.
4
4
.
.
2
2
.
.
8
8
B
B
i
i
n
n
d
d
I
I
P
P
t
t
o
o
M
M
A
A
C
C
This function is used to bind the IP and MAC address in LAN to have a strengthening control
in network. When this function is enabled, all the assigned IP and MAC address binding
together cannot be changed. If you modified the binding IP or MAC address, it might cause
you not access into the Internet.
Click LAN and click Bind IP to MAC to open the setup page.